Industry Information
The installation and debugging process of door closer is exp
Publish Time：2017/07/31 Click Rate：
分享到：
The closed door has not been widely used, especially in the family rarely someone to install the door closer, so for the installation and commissioning of a lot of people do not understand very well, although it looks very simple, but if it is installed or not debugging there will be a big security risk, the following and everyone together to talk about the specific process and mode for the installation of doors.
一、Press the position instructions on the mounting plate, confirm the location of the screws to be installed, and then start drilling and tapping.
二、Next, screw the door closer to the fuselage.
三、Install fixed connecting seat.
四、Install the driver plate by screws
五、djust the adjusting lever to a 90 degree position with the door frame, then connect the combo lever to the drive plate.
六、Fit the plastic lid, because the plastic cover can be used to catch the hydraulic oil leaked from the door closer.
七、After installation, we need to check whether the fixed screws are firm and must not be loose or unstable
八、Open the door to open to the maximum open position, and then check whether the rotating arm hinged door closer is the gate or door frame collision or friction.
After the above eight steps, a complete closed door device installation and commissioning is completed, in the installation process, the most important is to should see our screw is strong, if not firmly or loose for a closer buffer will have a certain impact, the existence of security risks.
一、Press the position instructions on the mounting plate, confirm the location of the screws to be installed, and then start drilling and tapping.
二、Next, screw the door closer to the fuselage.
三、Install fixed connecting seat.
四、Install the driver plate by screws
五、djust the adjusting lever to a 90 degree position with the door frame, then connect the combo lever to the drive plate.
六、Fit the plastic lid, because the plastic cover can be used to catch the hydraulic oil leaked from the door closer.
七、After installation, we need to check whether the fixed screws are firm and must not be loose or unstable
八、Open the door to open to the maximum open position, and then check whether the rotating arm hinged door closer is the gate or door frame collision or friction.
After the above eight steps, a complete closed door device installation and commissioning is completed, in the installation process, the most important is to should see our screw is strong, if not firmly or loose for a closer buffer will have a certain impact, the existence of security risks.
